Sink and faucet installation in Placerville

A clean, leak free install

Most sink and faucet jobs use the water and drain connections already under your counter, which makes them a perfect handyman project. The difference between a good install and a callback is in the details: snug connections, proper seals, and a careful leak test. That is where we take our time.

Kitchen or bathroom, drop in or under mount, single faucet or a full sink swap, we handle it and leave the cabinet dry.

How we install your sink

1. 1

   Shut off and remove

   We close the shutoff valves, disconnect the old faucet, drain, and sink, and clear the old sealant so we start with a clean opening.

2. 2

   Set the new sink

   We fit the new sink to the counter, seal it properly so no water seeps under the rim, and secure it for a solid, even mount.

3. 3

   Faucet and supply lines

   We mount the faucet and connect the hot and cold supply lines, swapping worn shutoff valves or braided lines while we are in there if needed.

4. 4

   Drain and disposal

   We assemble the drain and P trap, connect the garbage disposal if you have one, and make sure everything drains freely.

5. 5

   Test and clean up

   We run the water, check every joint for leaks, seal the edges, and wipe down the area so it is ready to use right away.

What we install

• checkKitchen sinks, drop in and under mount
• checkBathroom and vanity sinks
• checkKitchen and bathroom faucets
• checkGarbage disposals
• checkShutoff valves and supply lines
• checkDrains, P traps, and basket strainers